![]() “Turn on” the remote, tap on the device button (TV, DVD, CBL and OK/SEL) for 3 seconds.The LED light indicates the device is ready to program. Point out the remote to device and click on “CH+” & “CH-“ switches.Press “up” or “down” key continuously till the device will turn off. Verify the code by clicking on “power” key.If it starts, try changing the channel to verify that remote is programmed correctly. Now tap the “device” button to save the code.LED of Device will blink twice for confirming the code stored. How to Program Philips DVD Universal Remote With Manual Methodīy using the keycode we can easily program a universal remote and the keycode identifies the make and model of your equipment. Now press and hold the “Setup button” of the Universal Remote until it shows the “Light Flash” (It means it is in “Learning mode”).Press the “TV” on your “Philips DVD universal remote”. Once you’ve done this procedure, just “point your remote at the TV” and then “Press And Hold The Power” button.Finally enter the “Keycode” which you collected from the programing guide (Instructions Booklet). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |